SET UP/OPERATION
BASIC OPERATION GUIDE
1.
Press button to turn unit ON (*30 second delay
is normal if recently powered off)
2.
Display shows Preferred Humidity Setting on Left
and Current Humidity on Right
3.
Adjust
and
to set preferred humidity level
(90% to 26%)
4.
Unit will run automatically, turning on and off to
maintain desired humidity level
5.
To run
continuously
press
to below 26% until
“CO” displays
6.
Once job is complete, press button to turn the
unit off. The water pump will automatically purge for
40 seconds to drain.
Always operate unit in an enclosed area, closing all
doors, windows and other pathways open to
external areas for maximum water removal
efficiency
Keep traffic through drying area to a minimum
Place the dehumidifier in the center of the room
away from walls and furnishings.
(Fig. A)
Uncoil entire drainage hose on rear of unit.
Place
open end of hose into a drain, bucket, or outdoors.
Ensure drainage hose is not restricted or kinked.
DO NOT
elevate hose higher than 15 ft. above unit.
(Fig B)
Take care that water does not create a slip hazard. If
using a collection bucket check water level regularly.
READ ALL INSTRUCTIONS TO PREVENT SYSTEM DAMAGE
For proper operation, DO NOT obstruct the air inlets/outlets, or drainage hose.
WAIT 30 minutes after transporting unit to jobsite
before switching ON
to allow refrigerant system to
stabilize
DO NOT
switch the power OFF
by disconnecting power cord
WAIT at least three minutes after turning the power OFF to move unit.
FIG. A
FIG. B
