- 29 -
2. safety and information
2.1 information on use
1. Carefully read this booklet before installation and use.
2. Before starting the product, make sure earthing has been performed.
3. Pay particular attention to the symbols used in this booklet.
General electrical hazard risk. If ignored, it may cause damage to the electrical pump and to persons.
Hazard caused by electrical equipment. If ignored, it may cause damage to the electrical pump and to.
4. Any damage caused by failure to comply with the instructions and safety measures provided in this booklet
shall not be borne by our company, but exclusively by those who have ignored the standards.
5. General safety indications
1. Make sure to use the correct electrical power supply required by the product.
2. During installation and maintenance, make sure to have disconnected general power.
Before using the product, make sure correct earthing has been performed.
3. If the pump remains inactive for a long time, close the water supply valve and disconnect the electrical
power supply.
4. Do not install the electrical pump in locations that might get exposed to water.
5. If the product remains unused for 2 years, gradually increase the pressure via the voltage regulator,
since there is the risk of receiving an electric shock.
6. Do not touch the control terminals when the equipment is on since there is the risk of receiving an
electric shock.
7. Maintenance must be performed 5 minutes after equipment shut-down. The relative indicator must be
fully off in order to not receive an electric shock.
8. Make sure your hands are completely dry before using the control panel, in order to not risk receiving
an electric shock.
9. If wiring or wires are worn, have them replaced by qualified personnel.
HAZARD
GB
