[10]
Ancillaries:
The following ancillaries and spares are available for the Xplus2 EC RFH product range:
92433AW: €125mm Spigot
92435AW: Blanking Plate
Spares:
41983SK: Replacement electrical cover
42063SK: Replacement termination plug and screws
41987SK: Replacement Inlet Housing (Green)
[3]
humidity speed setting for a set time delay before returning to Day-time speed setting. The fan will default to
this Auto setting when initially switched on.
All speeds are installer set on the integral PCB.
The fan is designed to run continuously 24 hours a day. It is fitted with one of the world’s most energy efficient
electronic motors.
Maintenance
In normal running conditions the fan attracts very little dirt. However it may be advisable to have the unit inspected by
your installer annually and clean if necessary (Making sure that water does not get into the motor or electrical
termination box).
CE-Conformity:
This unit meets all relevant CE standards.
Characteristics:
The electric motor and fan are enclosed in the ventilator casing. Attached to the casing is up to 6 – €125mm extract
spigots or blanking covers. Air is exhausted through 1 – €125mm spigot built into the casing.
Setting up the Xplus2 EC RFH and planning the system layout:
Example
Installation
:
The installation should aim to minimise resistance and prevent any leakage in the ducting. Where possible the use of
flexible ducting should be minimised and should be connected using a short section of flexible ducting (no greater than
0.5 metres).
IMPORTANT:
READ THESE INSTRUCTIONS BEFORE COMMENCING THE INSTALLATION
