Series EJ, ET, EY, FJ & FR
102002-177 Rev M2
17
\1020\02177M2.doc 17 Jun 2019
INITIAL TURN ON
WARNING
!
This procedure should only be attempted by qualified
personnel who are knowledgeable in methods of safely testing and operating
high voltage power supplies and related high voltage equipment. The
following steps to connect and operate this equipment should be carried out
only after the unit has been placed or mounted in position.
1.
CAUTION:
Check the input voltage switch (S3) setting on the rear
panel of the power supply and make certain that this is the rating of the
available power source. For units without a selector switch, make
certain the AC power source matches the rating shown on the model
label.
2.
Check to see that the POWER switch is in the off (“0”) position.
3.
FOR LOCAL CONTROL (Not applicable for “NC” option):
Using the
supplied “D” connector kit, make connections as shown in figure 12 of the
INTERFACE DIAGRAM.
FOR REMOTE ANALOG CONROL:
Using the supplied “D” connector
kit, connect external pots or control signals to REMOTE V-PROGRAM and
REMOTE I-PROGRAM terminals. Connect HV ENABLE to REFERENCE.
See INTERFACE DIAGRAM figures 2, 3, 4, 11, & 12.
FOR REMOTE DIGITAL CONTROL:
Connect a digital interface (RS-
232, USB or optional Ethernet) to a control computer. Using the supplied
“D” connector kit, make connections as shown in figure 12 of the
INTERFACE DIAGRAM.
Note: Always connect J3-1 (GROUND) to J3-2 (COMMON) unless
COMMON needs to “float” for isolation or metering purposes.
4.
Connect the high voltage output cable to your HV apparatus and ground the
return lead of the load as shown in Figures 11 & 12 of INTERFACE
DIAGRAM. Connect the high voltage cable to the receptacle on the rear
panel.
WARNING
!
Make sure to isolate your HV apparatus/load from any
possible contact with other objects and personnel.
“NC” OPTION USERS: Monitor the V-MONITOR
terminal with a DVM (0 - 10VDC = 0 - rated kV
output), or monitor the voltage on a remote computer.
5.
Connect the AC input cable provided to J4 and to the power source.