20
Symptom(s)
Breaker/Fuse keeps
blowing
Device has no power
Fixture is not
responding to DMX
Loss of signal
COLOR-CON
Controller does not
function, or does not
function properly
Stand alone
operation
The display is only
showing: ####
Possible Solution(s)
Check total load placed on the electrical circuit
Check for a short in the electrical wiring: internal and/or external
Check for power on Mains
-Note: In the event of autoswitching transformer failure, the unit
can be sent in for repair; however, a replacement part can be
ordered directly from Our company
Check Control Panel settings for correct addressing
Check DMX cables
Check polarity switch settings on the controller
Check cable connections
Call service technician
-Note: In the event of Display PCB failure, a replacement PCB
can be ordered directly from Our company
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables or black
lights
Make sure connector is firmly connected to device
This fixture must be in the correct mode in order to properly
respond to the COLOR-CON controller. The correct mode is
“DMX” in the onboard Control Panel
This fixture has built-in, automatic programs that may be
triggered from the onboard Control Board
The password lockout has been enabled. you can use the
password: { MODE
、
UP
、
MODE
、
DOWN
、
MODE
、
UP
、
MODE
、
DOWN }
