11
11. Disconnect the water tubes
When you are finished using XMG OASIS and you intend to disconnect
the water tubes, please follow these instructions:
1.
As a precaution, shut down the laptop or send it to hibernate mode.
Sending it merely to standby mode is
not
sufficiently safe.
2.
Disconnect the power adapter from XMG OASIS and disconnect the
DC cable of XMG OASIS from your laptop.
3.
Keep a handkerchief, tissue paper or microfiber cloth ready on hand.
There will be small droplets of liquid emerging during the next step.
Remove them as soon as they emerge.
4.
Gently squeeze the lo
ck mechanism of the quick release connector
and swiftly remove it from the laptop
horizontally.
5.
Inspect the area around the water ports of the laptop for liquid
droplets. Remove all fluids, keep all surfaces clean and dry.
6.
Now close the rubber seal of the laptop.
This operation may cause
additional liquid to be squeezed out
around the edges and the
ventilation hole of the rubber seal. Inspect the area again and
clear
off all remaining fluids
. Make sure the rubber seal is fully closed and
all surfaces are clean and dry.
⚠
Leak warning:
make sure that XMG OASIS is turned off before you remove
the water tubes. If you disconnect during operation, the water pressure
caused by the operating pump will cause additional leakage.
⚠
Heat warning:
if you have been using the laptop with the tubes connected
but with XMG OASIS
not
running, the quick release connector (which is
metal-made) may have accumulated a lot of heat from the temperature
generated by the system. Please make sure to test the connector’s
temperature with a quick touch before fully grasping it.
Squeeze the
quick release connector and
remove it from the l
aptop horizontally.