2. MOVING THE CAGE TO THE REAR POSITION
(for aerobar extensions between 70 and 84mm center-to-center):
There are two possible positions for the cage so it can be adjusted to the ideal position; the mount comes preassembled in the forward
position.
1.
Remove the two cage screws (C)
using a 3mm Hex L-Wrench and an 8mm open ended wrench. There are two thin black
spacers (D) between the cage and the computer mount, and two thick silver spacers (E) between the computer mount and
the flate plate; these will need to be retained for later.
2. Move the cage
and computer mount rearward to the back position.
3. Insert the front cage screw (C)
by placing it back through the front slot in the cage, through the thin black spacer (D),
through the computer mount, through the thick silver spacer (E) and through the second hole from the front in the plate.
Thread one of the lock nuts onto the screw on the underside of the plate but do not tighten.
4. Insert the rear cage screw (C)
by placing it back through the rear slot in the cage, through the thin black spacer (D),
through the computer mount, through the thick silver spacer (E) and through the furthest back hole in the plate. Thread
the remaining lock nut onto the screw on the underside of the plate but do not tighten.
5. Tighten the two cage screws (C)
by tightening the front screw as much as possible and torquing the rear screw to
20 in lbs (2.3 Nm).
3. GARMIN MULTISPORT WATCHES
TOOLS REQUIRED
2mm Hex Wrench
Torque Wrench up to 10 in lbs (1.1 Nm)
- For Garmin Fenix and Forerunner users, the computer mount insert will need to be rotated. Remove the two M3 flat head
screws (G) at the top of the computer mount and rotate the inner piece 90° so the screw holes are at the sides rather than
at the front and back. Reattach the M3 flat head screws and tighten to 10 in lbs (1.1 Nm) of torque.
4. WARNING
- To prevent damage to the system, when removing the
TORPEDO KOMPACT
from the bike, pull upwards from the
flat plate itself.
WARRANTY:
TORPEDO KOMPACT
system has a 1 year limited warranty. See website for details.
TOOLS REQUIRED:
3mm Hex L-Wrench
8mm Open Ended Wrench
Torque Wrench up to 20 in lbs (2.3 Nm)
