4/11/2020
XKITZ XAPS-10WB
2
Powering the XOVER-2 or XOVER_3 Crossovers
The XAPS-10WB was designed primarily to power the XOVER-2B or XOVER-3B fully balanced crossovers,
but it can also be used to power the XOVER-2 or XOVER-3 crossovers. These crossovers use only a single
positive power supply, so the (-) outputs of XAPS-10WB will not be used.
You’ll need to cut off the snap-in connector on the crossover side of the cable (since the XOVER-2/3
boards have a terminal block for power supply connection). Just connect the center wire (GND) from the
power supply to the (-) input on the terminal block and connect the (+) wire from the power supply to the
(+) input on the terminal block. This will give the crossovers approximately 22-24V DC, which is ideal for
the XOVER-2/3 boards.
Leave the wire from the (-) output of the power supply unconnected, or just cut it off, it won’t be needed.
