12
Step 4 — Connect cables to the Array
Step 4 — Connect cables to the Array
Remove the snap-on cover from the Array so that you can observe the Array’s LEDs after
you connect the cables.
Connections are slightly different for the XN8 and the XN4. Use the proper procedure
below.
To connect the XN4
Connect Cat 5e
from PoGE
Injector to
GIGABIT1
1.
Connect the Cat 5e data cable from the injector’s
OUT
port to the Array’s
GIGABIT1
port. (
Figure 8. XN4 Power/Data Connections
To connect the XN8
Connect Data
OUT
to
GIGABIT1
port
with short cable
Connect Cat 5e
from PoGE
Injector
to
IN
port
NOTE:
Do
not
connect the data cable from the injector to a Gigabit port on the
XN8
Array! It
must
be connected to the
IN
port (on the right in Figure 9).
1.
Connect the Cat 5e data cable from the injector’s
OUT
port to the Array’s Data and
Power
IN
port as shown in
.
Figure 9. XN8 Power/Data Connections
2.
Connect the supplied short (approx. 6”) Cat 5e data cable from the Array’s Data
OUT
port to the uplink port,
GIGABIT1
.
4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
