iii
Attension
1. Please install and use this product under the environmental conditions specified in the general specifications of
the manual.
Do not use in damp, high temperature, places with dust, smoke, conductive dust, corrosive gas, flammable gas,
vibration and impact.
It may cause electric shock, fire, misoperation, product damage, etc.
2. Do not directly touch the conductive part of the product.
It may cause malfunction and fault.
3. Please use DIN46277 guide rail, M3 screw or Xinje XG-EB to fix the product and install it on a flat surface.
Incorrect installation may cause malfunction and product damage.
4. When processing the screw hole, please do not let the cutting powder and wire debris fall into the product
cover.
It may cause malfunction and fault.
5. when connecting the expansion module with the expansion cable, please confirm that the connection is tight
and the contact is good.
It may lead to poor communication and misoperation.
6. when connecting peripheral devices, expansion devices, batteries and other devices, be sure to cut off power for
operation.
It may cause malfunction and fault.
⚫
Product wiring
Danger
1. Before wiring the controller, be sure to disconnect all external power supplies.
Danger of electric shock.
2. Please correctly connect the DC power supply to the dedicated power terminal of the controller.
If the power supply is connected incorrectly, the controller may be burned.
3. Before the controller is powered on and operated, please cover the cover plate on the terminal block.
Danger of electric shock.
Attension
1. Do not use external 24V power supply to connect to 24V and 0V terminals of the controller or expansion
module.
It may cause damage to the product.
2. Please use 2mm
2
wire to carry out the third kind of grounding for the grounding terminal of the controller and
expansion equipment, and do not share the grounding with the strong current system.
It may cause failure, product damage, etc.
3. Do not make external wiring to the empty terminal.
It may cause malfunction and product damage.
4. When processing the screw hole, please do not let the cutting powder and wire debris fall into the product
cover.
