Xinje DP3C Series, User Manual

Page: 24 / 32

23
Bit Value Explanation
8
0 switch off Touch probe 2
Stop/run Touch probe2
1 enable Touch probe 2
9
0 Trigger first event
Touch probe2 mode selection
(single/continuous)
1 Continuous
10
0 Trigger with Touch probe2 input Touch probe2 trigger
selection
(external input/phase Z)
1 Trigger with zero impulse signal of position encoder
11 0 Reserved not used
12
0 switch off sampling at positive edge of touch probe2
Touch probe 2 rising edge
selected
1 enable sampling at positive edge of touch probe2
13
0 switch off sampling at negative edge of touch probe2
Touch probe 2 falling edge
selected
1 enable sampling at negative edge of touch probe2
14-15 0 Reserved
The user can obtain the current state of the probe from the object 60B9h. The following is the description of bit
corresponding to 60B9h.
Bit Value Explanation
0
0 Touch probe1 is switch off Probe 1 action stop
1 Touch probe1 is enabled Probe 1 in action
1
0 Touch probe1 no positive edge value stored Rising edge probe 1
incomplete status
1 Touch probe1 positive edge value stored Rising edge probe 1
completion status
2
0 Touch probe1 no negative edge value stored Falling edge probe 1
incomplete state
1 Touch probe1 negative edge value stored Falling edge probe 1
completion status
3-5 - reserved not used
6-7 - Not supported not used
8
0 Touch probe2 is switch off Probe 2 action stop
1 Touch probe2 is enabled Probe 2in action
9
0 Touch probe2 no positive edge value stored Rising edge probe
2incomplete status
1 Touch probe2 positive edge value stored Rising edge probe 2
completion status
10
Touch probe2 no negative edge value stored Falling edge probe 2
incomplete state
Touch probe2negative edge value stored Falling edge probe 2
completion status
11-13 - Reserved not used
14-15 - Not supported not used