9
Power source wiring
13.8V external DC power supply can be used for X6100.
The current load capacity of DC power supply
shall be at least 3.5A.
Attached power lines can be used to connect to radio and DC power supply.
DC power supply shall be connected in strict accordance with following figure to avoid reverse polarity
connection.
■
EMC magnet ring can be applied on power lines to prevent external disturbance from entering radio
via power lines and radio-frequency interference in radio from radiating externally via power lines when
external power supply is adopted for X6100. Magnet ring shall be installed at the side closing to radio to
greatest extent.
Charging
The X6100 radio shall be charged by the attached charging adapter.
The radio can be charged by
connecting the AC end of charging adapter with electric supply and inserting the output end into the DC
interface at the left of X6100.
The host will automatically stop charging once the charge is completed.
Note :
■
Polarity of power lines shall be carefully inspected to avoid reverse polarity connection when external
power supply is adopted.
■
Reverse connection of power may cause severe damage to the radio.
■
Do not charge the radio with any other charger that does not meet the specifications. Otherwise, the
device may be damaged
Caution!
1. The charging adapter can only charge the X6100 and cannot be used for transmitting as there is a risk of
damaging the device.
2. Under no circumstances shall the DC port on the left of the X6100 be connected to a voltage higher than
15VDC. Otherwise, serious device damage may occur.
