Note: Polarity symbols should
match on each component.
Contact Here
Solderless strip-to-wire connector
3
• Peel away a portion of the light strip adhesive backing at one end.
• Open the solderless strip-to-wire connector, and slide the strip
end all the way into the solderless strip-to-wire connector.
• Close the hinged strip-to-wire connector.
4
• Remove the remaining adhesive backing and attach the light strip
to the desired surface.
• Press firmly to ensure proper adhesion.
1
DIRECT INSTALLATION ON SURFACE
• Using a lint-free cloth, wipe the installation surface with 50/50
alcohol solution to ensure a clean mounting surface free of
oils, silicones and dirt particles.
• A smooth mounting surface is required to ensure proper
adhesion.
XFL product
2
• After measuring mounting location, carefully cut the light strip to
desired length.
• Make sure to ONLY cut along the dashed lines provided. These
dashed lines divide two sets of positive and negative connection
points.
Rev 1.2 | February, 2022
4
WET LOCATION
DC ONLY
XFL Flexible Linear LED Light Installation Instructions