Ensure the power adapter used meets the requirements of Clause 6.4.5 in
IEC/EN 62368-1 and has been tested and approved according to national or
local standards.
Frequency Bands and Power
This mobile phone offers the following frequency bands in EU areas only and
maximum radio-frequency power:
GSM 900: 35.5 dBm
GSM 1800: 32.5 dBm
WCDMA band 1/8: 25.7 dBm
LTE band 1/3/7/8/20/28/38/40: 25.7 dBm
Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm
Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 20 dBm, 5470 to
5725 MHz: 20 dBm, 5725 to 5825 MHz: 14 dBm
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio
waves. This device is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy. The exposure standard
for wireless devices employs a unit of measurement known as Specific
Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device
has been tested and meets the FCC RF exposure guidelines for use with an
accessory that contains no metal and positions the device a minimum of
1.5 cm from the body. RF exposure compliance with any body-worn accessory
that contains metal was not tested and certified, and use of such body-worn
accessory should be avoided. Any accessory used with this device for
body-worn operation must keep the device a minimum of 1.5 cm away from
the body.
