Xhorse SK283, User Manual

Page: 20 / 48

BMW TOOL User Manual
20
Ver: 1.1
(PICTURE 5.17)
3)
In (PICTURE 5.1), use Save Key Info save the read key info
4)
There’s 2 methods for make key:

Method 1: In (PICTURE 5.1), select Prepare dealer key with programmer
a) Input a new blank key to VVDI2 programmer
b) Select a key position for new key (If the selected position have key already, must
use Add Key to add new key to CAS system)
c) In (PICTURE 5.1), press button Prepare dealer key with programmer wait
procedure complete
d) After make dealer key successful, try start directly. If can start engine, turn to step
7). If not work, add the made key to CAS system with Add Key in (PICTURE 5.1)
e) After new key can start engine turn to step 7). Attention: Sometimes add new
key for CAS1/CAS2/CAS3 will cause car not start, you can follow chapter 4
Special Note 2

Method 2: In (PICTURE 5.1), select Prepare dealer key with ignition switch ,
select key type and pre-process the blank key, insert to ignition switch and wait
complete. After finish, turn to step 7). If you get failure here, you need unlock the
key with key info before next make dealer key
5) Complete.
5.3.2.
Lost All Key

Attention: Under these steps, there will come some ASK or NOTE message,
they all can be found in chapter 5.2

Operation steps:
1)
Active OBD communication with lost all key method
2)
In
(PICTURE 5.1)
, use Connect to detect CAS type and read CAS identification
information ( Remember: Write down CAS ID )
3) In use Get Key Info read CAS immo data, cutting code, remote frequency and etc.