ENABLE/DISABLE RELAYS
This function allows the disablement of one or more of the panel’s 3 auxiliary relays from activating as pro-
grammed. When selected, press the accept
4
button and a window similar to the one below will appear:-
Select the relay (1, 2 or 3) to be disabled/enabled using the
5
and
6
buttons.
When the desired relay has been selected, press the accept
4
button and the relay’s status (Enabled
or Disabled) will flash. Next, use the
5
and
6
buttons to toggle between enabled and disabled and
press accept
4
button to select the desired option. The window will now move to the next relay
allowing further enablements or disablements to be made. Alternatively, to return to the previous
menu press the escape
3
button.
ENABLE/DISABLE DEVICES
This function allows loop devices to be disabled from reporting faults, fires, pre-alarms, etc., and is
normally used to temporarily disable detectors/call points that are nuisance tripping. When selected,
press the accept
4
button and a window similar to the one below will appear:-
Use the
5
and
6
buttons to select the zone where the device you wish to disable/enable is located.
When selected, press the accept
4
button and a list of all devices that can be disabled or enabled in
that zone will appear, e.g
Use the
5
and
6
buttons to scroll through the available devices. When the desired device appears,
press the accept
4
button and the device’s status (Enabled or Disabled) will flash. Next, use the
5
and
6
buttons to toggle between enabled and disabled and press the accept
4
button to select
the desired option. The window will now move to the next device allowing further enablements or
disablements to be made. Alternatively, to return to the previous menu press the escape
3
button.
Please note: if all the input devices on a zone are individually disabled, the zone they belong to will
also be disabled. If you try to re-enable a zone which has no enabled devices on it using the
ENABLE/DISABLE ZONES function described on page 17, a prompt appears saying this cannot be done.
Instead you must first enable at least one device on the zone before re-enabling the zone itself.
ENABLE/DISABLE FAULT RELAY
This function can be used to suppress the panel’s fault relay from activating in a fault condition.
When selected, press the accept
4
button and the following window will appear:-
Use the
5
and
6
buttons to toggle between enabled and disabled and press the accept
4
button to
select the desired option. Alternatively, to return to the previous menu press the escape
3
button.
ENABLE/DISABLE OUTPUT DELAYS
This function can be used to globally disable or enable any delays to outputs that have been programmed
into the panel. When selected, press the accept
4
button and the following window will appear:-
Use the
5
and
6
buttons to toggle between enabled and disabled and press the accept
4
button to
select the desired option. Alternatively, to return to the previous menu press the escape
3
button.
XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000501 Rev 2 • Page 18 of 28
XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
Select Zones:- 1: Shop Floor
Shop Floor:- 1: Gent WC
Loop 1, Device 3: Enabled
Fault relay is:- Enabled
Panel Relay:- 1
Delays to Outputs are:-
Enabled
