17
Customizing Your WorkCentre
Programmable Feature Settings 0 – 7, and 14
To change the programmable features (refer to the Control Panel), find the
Program Number and the desired Option Number in the Programmable
features chart on the following pages. Follow the instructions below.
1.
Select the
Toner Saver
in Copy Quality.
2.
Press again and hold the
Copy Quality
button for approximately 4 to 6
seconds.
•
The light next to Auto will light.
•
The lights within the WorkCentre Diagram will flash.
3.
From the table on the following page, select the Program Number of the
feature to be changed. Enter the selection using the
10
button.
4.
Press
Start
.
•
The current setting for that program will flash.
5.
Press the
1
button until the option number you want is displayed.
6.
Press
Start
to store the selection.
NOTE: To continue making other changes press the Clear button and
repeat steps 3 - 7. Press the Copy Quality button to return to the copy
mode.
Programmable Feature Setting 10
Use the following procedure to change the preset Reduction/Enlargement
default setting. This feature allows you to set a specific preset reduction or
enlargement between 50-200%.
1.
Select the
Toner Saver
.
2.
Press again and hold the
Copy Quality
button for approximately 4 to 6
seconds.
•
The light next to Auto will light.
•
The lights within the WorkCentre Diagram will flash.
3.
Press the
10
button until the number 10 is displayed.
4.
Press
Start
.
•
The current reduction/enlargement setting will flash.
5.
Press the
Variable Percentage
buttons until the desired percentage is
displayed.
