REP 4.10 Printer Output Drive
Roller
Parts List on PL 4.3
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. Remove upper printer assembly (REP 4.7).
7. Remove printer output drive roller.
(Figure 1)
a.
Remove E-ring securing printer
output drive clutch.
b.
If nylon washer is installed next to E-
ring, remove nylon washer.
c.
Remove printer output drive clutch
and output drive spacer.
d.
Remove the two E-rings securing RH
and LH printer output drive bearings.
e.
Remove printer output drive roller.
Replacement
NOTE: Some terminals have a nylon washer
installed between the E-ring and the right side
of the printer output drive clutch. Be sure to
reinstall it, if it was previously installed.
Reinstall in reverse order.
12/88
REP 4.10
4-30
Telecopier 7017 / 7017SF
www.printcopy.info
www.printcopy.info
