32
Phaser 860 Color Printer
Printer Management
SysStart Job execution
You may load a startup file (
SysStart
) onto the printer’s internal hard disk, if installed. The
SysStart
file is similar to an
init
file — when you turn on or reset the printer, the file
executes.
There are three methods for turning on/turning off SysStart:
■
From the printer’s front panel
■
Using CentreWare IS Printer Management software
■
Using utility files
Note
If the
SysStart
file contains an error, the printer ignores the remainder of the file
and may not start up as expected.
To turn on/turn off the execution of the SysStart job from the printer’s front panel:
1.
With
Menus
highlighted, press the
OK
key.
2.
Scroll to
Printer Setup Menu
by pressing the
Scroll Up
or
Scroll Down
key.
3.
Press the
OK
key.
4.
Scroll to
Startup Mode
. The end of the line also displays the setting (
On
or
Off
).
5.
To change the setting, press the
OK
key.
6.
To make the change take affect, reset the printer.
To turn on/turn off the execution of the SysStart job using CentreWare IS Printer
Management software:
1.
From your printer’s Internet Services home page, click
Properties
.
2.
On the left side of the
Properties
page in CentreWare IS, click
Printer Defaults
.
3.
If desired, change the setting for
System Start Job
(under
User Preferences
on the
Printer Defaults
page).
4.
Click the
Save Changes
button on the bottom of the page.
5.
To make the change take affect, reset the printer.
To turn on/turn off the execution of the SysStart job using utility files:
■
Macintosh:
■
Set SysStart Job
— Turns on automatic execution of the SysStart job
■
No SysStart Job
— Turns off automatic execution of the SysStart job
Refer to page 38 for downloading instructions.
To make the change take affect, reset the printer.
