Xerox Phaser 5335, Printing Manual

Page: 88 / 110

76
Setting the ESC/P Mode
NOTE: When [Character Range] is changed from [Extended] to [Normal], the left and right
margins will be reset to the defaults.
When the right margin is set by a command, the position specified by the command will be
the right edge.
„
Character Mode
Character Mode is a feature that sends printer control commands in characters
instead of in hexadecimal numbers. When sending printer control commands from
an IBM host computer through a computer that supports Character Mode, set the
start character string to "&$%&" or "$?!#".
The following options are available:
[Off] (default)
Disables Character Mode.
["&$%&" Entry]
Uses "&$%&" as the start character string.
["$?!#" Entry]
Uses “$?!#" as the start character string.
ESC/P Switch
NOTE: The values for [Text], [Minimum Text], [Char. Code Table], [Page Length], and [1
inch Skip] are not affected by extension commands sent from users.
„
Text
Sets the print quality mode to [High Quality] (default) or [Draft].
NOTE: This only changes the status of the setting and not the actual print quality.
This setting is affected by “Text” commands sent from users.
„
Minimum Text
Sets whether or not to reduce the size of single-byte characters when printing.
The following options are available:
[Off] (default)
Prints single-byte characters without reducing their sizes.
[On]
Prints single-byte characters in reduced sizes.
„
Char. Code Table
If the Chinese font kit is installed, select the type of character code table for single-
byte characters. The options are [Graphics] (default) and [Slant].
„
Page Length
Sets the length of one page (printable area) to [11 Inches] (default) or [12 Inches].