Xerox 4590 EPS/4110 EPS System Administration Guide
4-17
4. Setups
Auto power saver
This machine provides a Power Saver mode used to reduce
power consumption when the machine is inactive.
In power saving mode, there is a Low Power mode and a Sleep
mode. When the set time has elapsed, these modes are switched
to in the following sequence:
Last operation on the machine
J
Low Power mode
J
Sleep
mode
To activate the Power Saver feature, set the Sleep Mode button to
Enabled
, and set the Low Power mode and the Sleep mode time
intervals using the following procedure.
NOTE: The amount of time that passes before the machine enters
Low Power mode and Sleep mode can be specified in 1 minute
increments, from 1 to 240 minutes for each mode.
1.
From the
Machine Clock/Timers
screen, select
Auto Power
Saver
, and select
Change Settings
.
2.
Using the
,
configure a power saver mode migration time
in 1 minute increments for Low Power mode and Sleep mode.
•
From Last Selection to Low Power Mode:
Set the time
to go from last operation to Low Power mode.
NOTE: The time From Last Operation to Low Power Mode
cannot exceed the time From Last Operation to Sleep
Mode. The default is 15 minutes.
•
From Last Selection to Sleep Mode:
Set the time to
move to the Sleep Mode after the last operation.
NOTE: The default for From Last Selection to Sleep Mode
is 60 minutes. Configure the From Last Selection to Sleep
Mode time to be longer than the From Last Selection to Low
Power Mode time.
3.
Select
Save
to save the settings and return to the previous
window.
