Xerox FaxCentre F2121, User Manual

Page: 34 / 112

- 34 -
This document is intended for installing the F
2121
on the network using a DHCP server to assign a
TCP/IP address.
Note: If you have not done so, you must enable network connectivity using the Blue Smart Card see Network/LAN kit for
instructions
Before Starting:
1. Confirm that an existing operational network utilizing TCP/IP is available.
2. Confirm that the Ethernet cable is plugged into the FaxCentre F
2121
and into an operational Ethernet port on the
network. Note: the Ethernet cable must be Category 5 and the connector must be RJ45 type. This cable is not supplied
by Xerox.
3. Confirm that a DHCP server with available IP addresses is accessible.
Configuring the
FaxCentre F 2121
with an IP address using AUTO (DHCP): On startup the FaxCentre F
2121
Multifunction
device defaults to DHCP to obtain its network configurations. A DHCP server delivers an IP address as well as other
configuration settings to the device. If using a DHCP server to allocate an IP address to the F
2121
device then proceed as
follows:
Step 1: Power on the FaxCentre F
2121
device, the device will say PLEASE WAIT SEL-CONF .
Step 2: Wait a minute or so while the F
2121
device negotiates an IP address. Once an IP address has been assigned, print out
the List of Parameters Page.
To Print the List of Parameters Page:
•
Select the
M
button on the F
2121
•
Scroll to 5 PRINT select OK
•
Scroll to 54 SETUP select OK
The List of Parameters Page will print out.
•
Confirm on the printout that an IP address has been allocated
and that it appears to be an appropriate IP address on your
network.
Note: if the IP address on the
Connectivity report starts with a
169.xxx.xxx.xxx then the DHCP
server has not properly
allocated an address or DHCP
is not enabled on your network.
Step 3: Record the IP address allocated and open your Internet Explorer browser. Type in the URL http://xxx.xxx.xxx.xxx
(where the xxx’s represent F
2121
device’s IP address). If connected properly you should be presented with FaxCentre F
2121
device’s Internet Services web page. If the Internet Services web page does not appear then test connectivity by pinging the IP
address of the FaxCentre F
2121
or contacting the local network administrator.
Step 4: Load the Print Drivers on the workstations that wil
l be accessing the FaxCentre F
2121
device.
N
ETWORK
S
ETUP
(A
UTO
)
LU 252813189 Kit Laser Multifonction LAN XEROX GB.book Page 34 Lundi, 27. novembre 2006 4:47 16