Xerox DocuPrint N4525, Advanced Features And Troubleshooting Manual

Page: 60 / 138

44 DocuPrint N4525 Network Laser Printer
Advanced Features
Note
If the leading edge width of the non-standard size being used differs from that of
the standard size selected in the
Custom Size
setting by more than 1/4 inch,
you cannot use the duplex or stapler options.
For example, to use 8 x 10 in. paper in the MBF:
a.
Set the Tray menu’s
MBF Size
menu item to
Custom
, set the
Custom Size
to
Letter
(8.5 x 11”), and set the
Tray Sequence
menu item to a sequence that
does not include MBF, or to
Off
.
b.
In the application, format to the page for Letter size paper, setting the margins to
correctly position the image on 8 x 10” paper if overlaid by Letter size paper.
c.
Load the 8 x 10” paper in the MBF.
d.
Request MBF as the paper source and send the job to the printer.
For example, to use 8.5 x 11 in. paper with short edge feed in the MBF:
a.
Set the Tray menu’s
MBF Size
menu item to
Custom
, set the
Custom Size
to
Folio
(8.5 x 13”), and set the
Tray Sequence
menu item to a sequence that
does not include MBF, or to
Off
.
b.
In the application, format the page for Folio size paper (because Folio is a short
edge feed size on this printer), setting the margins to correctly position the image
on the 11 inches to be used by this paper.
c.
Load the 8.5 x 11” paper in the short edge feed direction in the MBF.
d.
Request MBF as the paper source and send the job to the printer.
To use the Custom Paper Tray to print on custom paper sizes:
■ Specify the type of paper in the Custom Paper Tray. In the
Tray Menu
, set the
Custom Tray Type
menu item to the media type and then set the
Custom Size
menu item to the standard size to be used by PCL or PostScript to format the output
image on the page.
*
(In most cases, this will be the next larger standard paper size
from the custom size being used.)
■ In your application, format the page (including setting the margins) to ensure that the
image is properly positioned on the paper based on the standard size (that you
defined in the Tray menu).
∗
■ When you send the job to the printer, select the Tray by number.
* PCL and PostScript only format their output images to defined paper sizes.