Xerox DocuPrint 96 IPS Series, System Overview Manual

Page: 16 / 101

SYSTEM OVERVIEW
1-4 XEROX DOCUPRINT 96/4635/180 IPS SYSTEM OVERVIEW GUIDE
Host connectivity options
The IPS can be set up to receive data from a host in one of two ways:
•
Over a channel with bus and tag cable connection, via the Host
Channel Unit (HCU)
•
Through a Token Ring or Ethernet interface, using TCP/IP
protocol (not available in a VM or VSE host environment)
Note: A transmission rate of at least 16 megabits per second
should be used with a Token Ring interface on the IPS. (Overall
performance depends on network traffic and job density.)
Channel-attached configuration Figure 1-1 illustrates the components of a channel-attached IPS.
This configuration requires a Host Channel Unit (HCU) to interface
between the host channel and the IPS controller.
Figure 1-1. 96/4635/180 IPS: channel-attached configuration
1 Host system (PC or mainframe)
2 96, 4635, or 180 IPS printer
3 Printer interface cable
4 Printer Controller
5 SCSI interface
6 Host Channel Unit (HCU)
7 Bus and tag cables
TCP/IP configuration If you are using Token Ring or Ethernet with TCP/IP, as shown in
figure 1-2, the bus and tag cables and the HCU are not required.
Figure 1-2. 96/4635/180 IPS: TCP/IP configuration
1 Host system (PC or mainframe)
2 Token Ring or Ethernet network connection
3 Printer Controller
4 Printer interface cable
5 96, 4635, or 180 IPS printer
1
7
6
5
4
3
2