Xerox DocuPrint 4512, Setup Manual

Page: 14 / 196

S e t t i n g U p t h e D o c u P r i n t 4 5 1 2 / 4 5 1 2 N
12
❖
S e t t i n g U p G u i d e
Testing the
Printer
To test the printer, power it ON, then print a configuration sheet using
the Control Panel.
1
Power ON the printer and observe the following sequence on the
Control Panel:
The display reads
Self Test
.
The On Line light goes on.
The display reads
Emulation Size/Size
.
where
Emulation
is the emulation (PCL, PS2, Auto, HEX), and
Size/Size
is the size of paper in the upper tray/lower tray.
2
Press On Line .
The On Line light goes off.
The display reads
Printing Menu
.
3
Press Menu until:
The display reads Test Menu .
4 Press Item until:
The display reads
Config. Sheet
.
5
Press Enter .
The Data light goes on and the Configuration Sheet prints.
If the Configuration Sheet does not print, refer to Chapter 6:
Troubleshooting in the DocuPrint 4512/4512N User Guide.
When the page finishes printing, the DATA light goes off.
6 Press On Line .
The On Line light goes on.
The display reads Emulation Size/Size .
7 If you have purchased printer options, power off the printer, unplug
the power cord, and continue to “Installing Printer Options”
(page 13). Otherwise, skip to “Connecting to the Host” (page 14).