Scanning with the TWAIN Interface from PaperPort
100
DocuMate 510 Scanner User’s Guide
Setting Up PaperPort to Work with Your Scanner
On the PaperPort Scan Pane, when you selected a scanner from
the
Available Scanners
window, the
Scan
button at the bottom of
the panel should become active after approximately 5 to 10
seconds. If it doesn’t, you need to set up PaperPort to work with
your scanner.
NOTE:
Setting up PaperPort is a one-time-only process for
each option listed in the
Available Scanners
window.
Therefore, you may have to set up PaperPort once each for
TWAIN: Xerox DocuMate 510
and
WIA: Xerox DocuMate 510
.
The setup process is the same for each option. You will not have
to set up PaperPort again unless you uninstall the scanner and
PaperPort software, then re-install them.
If this Scan button is not active, you need to
set up PaperPort to work with your scanner.
Summary of Contents for DocuMate 510
Page 1: ...DocuMate 510 installation guide scanner...
Page 2: ...DocuMate 510 scanner installation guide...
Page 135: ...05 0591 600...
