Xerox CiPress 325, Web Threading Manual

Page: 41 / 60

8
Web Registration
Procedures
Once web threading is complete, you will need to register the web at the Primary CiPress™
and, if this is a tandem system, the Secondary CiPress™. Use the following procedure to
register the web prior to
Setting Up and Activating the Web Registration Module .
1. Open the Infeed Module Front Door and access the lower front left cavity of the
Infeed Module.
2. With a tape, measure the actual width of the web to the nearest millimeter. Record
the value. Use this value for the
web width
variable in the next step .
3. Use the following formulas to determine the target web edge position from the inside
of the Infeed Module Front Frame Plate.
Note
The actual web edge position should be /- 3 mm of the target web edge
position calculated.
a) If the web is at the Left Rear Metal tab on the Primary CiPress™, use the following
formula:
(577 mm) - (web width) = result
. An example of the formula for 18 inch (120
mm) width web is:
(577 mm) - (457 mm) = 120 mm
.
b) If the web is at the Right Rear Metal tab on the Primary CiPress™, use the following
formula:
(610 mm) - (web width) = Result
. An example of the formula using 20 inch
width web is:
(610 mm) - (508 mm) = 102 mm
.
8-1
Xerox
®
CiPress™ 325 / 500 Production Inkjet System
Web Threading Guide