Xerox ApeosPort-II 3000, User Manual

Page: 256 / 619

10 System Settings
254
Sys
tem
S
et
tin
g
s
10
System Settings Procedure
To make or change the system settings, it is necessary to enter the System
Administration mode.
This section describes the basic procedures for system settings. The following shows
the reference section for each procedure.
Step 1 Entering the System Administration Mode....................................................................254
Step 2 Entering the System Administrator User ID and Passcode ...........................................254
Step 3 Selecting an Operation Mode on the System Administrator Menu ...............................255
Step 4 Selecting a Menu Button on the [System Settings] Screen............................................255
Step 5 Setting a Feature ............................................................................................................256
Step 6 Exiting the System Administration Mode......................................................................256
Step 1 Entering the System Administration Mode
1
Press the <Log In/Out> button.
Step 2 Entering the System Administrator User ID and Passcode
To enter the System Administration mode, enter the system administrator User ID on
the login screen. If [Passcode Entry from Control Panel] in [Login Setup / Auditron
Administration] is activated, the passcode also needs to be entered.
It is recommended to change the system administrator user ID and passcode as soon as you install the
machine. For more information, refer to "System Administrator Settings" (P.337).
1
Enter the System Administrator ID
with the numeric keypad or a
keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note • The default System
Administrator ID is "11111".
When the Authentication
feature is enabled, a
passcode may be required
depending on the authentication type. The default passcode is "x-admin".
• The machine displays the following message if the system administration login failed:
"Login failed. Re-enter User Details and select Confirm."
• The machine displays the following message if the authentication failed more than the
specified number of times:
"You have made the maximum number of attempts to access the system. Access denied."
1 2 3
4 5 6
7 8 9
0 #
C
<Log In/Out>
button