SUPPLIES REQUIRED:
1. New toner (820g) for use in Phaser 5400
2. New drum for use in Phaser 5400
3. Replacement cartridge pins
4. New replacement chip
5. New doctor blade (optional)
6. New magnetic roller sleeve (optional)
7. Sealing strip
8. Cotton swabs
9. Isopropyl alcohol
10. Drum padding powder
11. Conductive grease
12. Dedicated magnetic roller cleaner
TOOLS REQUIRED:
1. Phillips head screwdriver
2. Small common screwdriver
3. Needle nose pliers
4. Spring hook
5. Vacuum approved for toner
XEROX PHASER 5400 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2010 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.
uninet
imaging.com
1. Turn the cartridge so that the handle is towards you (spring on the right). On either side of the cartridge is a white plastic pin
with one way screw heads. These pins are what hold and lock both halves together. Specialty drivers to remove them are not
available (at the time of this writing) so the only way to remove them (at the time of this writing), is to insert a 1” long or
#8 woodscrew into the center of the pin. Pull/pry out to remove. Leave the screws in so they can easily be installed.
