NOTICES
WARNING: Use of unsuitable materials may result in poor
performance and can possibly create a hazardous condition.
Always use a Xerox specified cordset with the Equipment Leakage
Circuit Interrupter/Residual Current Device (ELCI/RCD).
Use caution when installing or modifying telephone lines.
Do not do this
Never use an extension cord with the ELCI/RCD.
Never use the ELCI/RCD where water may enter the casing.
Never attempt any maintenance function that is not specifically
described in this document.
Never remove any covers or guards that are fastened with screws
unless otherwise instructed. There are no operator-serviceable
areas within these covers.
Never override or “cheat” electrical or mechanical devices.
Never operate the equipment if you notice unusual noises or
odors. Disconnect the power cord from the power source
receptacle and call your service representative to correct the
problem.
Never install telephone wiring during a lightening storm.
Never install telephone jacks in a wet location unless specifically
designated for wet locations.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electrical shock
from lightening.
Never use a telephone to report a gas leak in the vicinity of the
leak.
U.S. only: If you need any additional safety information
concerning the equipment or Xerox supplied materials, call the
following toll-free number: 1-800-828-6571.
Approvals and certification
60 Hz, 115 V
Listed by Underwriters Laboratories, UL1950 (UL). Meets CSA
standards, C22.2 NO 950 (CSA).
50 Hz, 220 to 240 V
Meets the British Standards Institution, IEC950 (BSI).
Safety feature
Your printer is equipped with an Equipment Leakage Circuit
Interrupter/Residual Current Device (ELCI/RCD). This safety
device protects you if an electric outlet supplying power to the
printer is improperly wired.
XEROX 4220 LPS FAX MODEM FOR MACINTOSH OPERATOR GUIDE
v
