Wireless LED HeadLight System (L2SWE) www.xenosys.co.kr
12
Warning – Do not use any other device randomly which may cause the defective reason.
In case of using non-Xenosys-supplied charger with higher voltage (over 5V), it will cause the
severe damage to main body. Please check if its Xenosys supplied charger and the serial
number. If it’s Xenosys supplied one, then stop using and contact the distributor (dealer) or
the manufacturer. If not, make sure to use Xenosys DC5V power supply.
OPERATING INSTRUCTION
Preparation before usage
1.
Check components
Components are shown on page 8~9. They can differ from the picture and replace or
delete with new parts for better performance.
2.
Charging battery & Assembling components
The battery is not completely charged, so charge them fully before the first-time usage.
①
Connect power supply & charger to supply the power.
②
If the battery is fully charged, it will show green light on charger LED.
③
Assemble the control unit & fully charged battery, then connect LED lens module wire
to the circular connector of the control unit.
B. Operating Instructions
1.
Finish the preparation and attach the main body to the universal clip or TTL frame (Note
that the battery pack must be removed).
2.
Assemble the desired battery pack to main body (Choose large(BTPWL) or
standard(BTPWS))
3.
Slightly touch Power ON/OFF button of main body from up to downward to turn on the LED
and change the position of lens module to your own needs to up or down, left or right.
4.
Adjust the intensity change switch to match your own needs of light intensity.
5.
Use the Illumination Area Adjustment Knob to set up your desired field of view.
WARNING – On turn-on LED, do not look directly into LED lens module or some one’s
