Xenics Bobcat-640-CL Industrial, User Manual

Page: 17 / 24

User Manual
Bobcat-640-GigE&CL Camera
Company confidential.
This document is the property of Xenics. It may not be reproduced – completely or partially – or passed to a third party
without written permission from Xenics.
Xenics nv T +32 16 38 99 00 Doc Ref: ENG-2012-UMN020
Ambachtenlaan 44 F +32 16 38 99 01 Issue: R000.12
BE-3001 Leuven

Belgium www.xenics.com Date: 29/10/2013
XF-104_02/20-01-2012
Page 17 of 24
4.2. Power Interface
The power cable must be connected to the backside
of the camera (see (Ref. 2) for its
location). Figure 4-1 lists the connector pins overview. Table 4-2 shows schematically the pin
location.
For a Bobcat-640-GigE, the power cable does not need to be connected to the camera in
case Power over Ethernet (PoE) is used.
Pin Signal
1 + 12V
2 + 12V
3 Gnd
4 Gnd
Figure 4-1 Camera power connector
Table 4-2 Camera power connector 12V
DC
Pin Signal
1 + 12V
2 + 12V
3 Gnd
4 Gnd
Figure 4-2 Cable connector Table 4-3 Cable connector 12V
DC
The power cable (ASY-001268) must be connected to the backside of the camera. Table
4-3 lists the connector pins overview. Figure 4-2 shows schematically the pin location of
the cable connector (Hirose HR10-7P-4P(73)) .
4 1
3 2
1 4
2 3