SU-200B
Installation Manual
This document is subject to change without prior notice.
17
⑥
Installation is successful if the following message appears.
< Reply from Default Gateway IP: bytes=32 time<xxms TTL=64 >
Figure 17 Checking the Ping Results
4.4 Resetting to Factory Default Mode
Use the reset button at the back of the SU-200B in order to reset the configuration into
factory default mode.
①
Turn off the power of the SU-200B.
②
Disconnect the RJ-45 cable.
③
Use a long sharp instrument (such as a tweezers) in order to push down on the reset
button.
④
Turn on the SU-200B while pushing down on the reset button.
⑤
Using the tweezers, push down on the reset button for 1 second. Wait at least 1
second before repeating the procedure. Repeat 3 times or more.
⑥
The LINK LED will blink when the SU-200B is changed to the factory default mode.
⑦
Reset the power.