16
X-Dive micro U-Boot
EN
Transmitter
·
Battery charging
•
WARNING:
check the transmitter LED also during operation. If the LED stops lighting up when
pushing a button, stop operation, switch the model off and replace the transmitter batteries –
crash
hazard!
Transmitter
Push to dive
Push to go up
Move forward
Move backward
Turn right
Turn left
Battery charging
WARNING:
Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
USB connector
Charging plug
Socket
open
insert
Position Pin
• Insert the charger into an USB socket of your PC.
• Connect the charging wire to the U-Boot (see picture).
•
WARNING:
the charging cable is polarized, pay attention to the guide rail in the connector housing.
The plug must snap into place relatively easily, do not use force -
fire or explosion hazard!
• During charging, the red LED on the charger lits. A fully discharged battery takes about 30 minutes until
it is fully charged - the red LED goes out.
• Unplug the battery from the charger.
• Unplug the charger from the socket when you no longer need it.
The run time of the X-Dive micro U-Boot is about 20 minutes.
Summary of Contents for X-Dive micro U-Boot yellow
Page 11: ...11 X Dive micro U Boot DE...
Page 30: ...30 X Dive micro U Boot...
Page 31: ...31 X Dive micro U Boot...
