XciteRC ONE12 series, User Manual

Page: 18 / 56

18 one12 Serie
EN
The remote control system
·
Charging the battery
The remote control system
Here you get an overview of the remote control system of your One12 and its various features and settings.
Before the first flight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position OFF.
• Now open the battery compartment cover on the bottom of the transmitter and insert two AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter. Pay attention to the correct
polarity!
+ -
• Close the battery compartment cover and turn on transmitter – push ON / OFF switch in position ON.
• The ted LED must lit. NOTE: If the red LED is still flashing after a few seconds, the model may not
be started – crash hazard! Change transmitter batteries immediately (or charge batteries).
• Pay attention to the LED’s also during operation. When the red LED starts flashing, stop driving as soon as
possible. If the LED expires, stop immediately and replace transmitter batteries (or recharge the batteries).
Transmitter
4
2
1
3
A
B
C
A: Steering wheel: direction right or left
B: Throttle trigger: controls the speed and direction of the
model
C: Battery compartment
1. Control trim: adjusts the straight ahead driving
2. Servoreverse steering
3. POWER LED: indicates the battery voltage
4. On / Off Switch: Turns the power of the transmitter ON
/ OFF
NOTE:
the adjuster for the servo reverse switch for
steering ST.REV must not be adjusted. So check the cor-
rect position before every ride: steering reverse: switch
points in antenna direction.
Charging the Battery:
Before the first use of your new model the drive battery needs to be charged with the included charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
For charging remove the battery from the vehicle.
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
• Insert the plug of the AC wall charger into the jack of the Micro-Charger, then plug the wall charger in an
appropriate mains socket 230 V/50 Hz – both LED’S (red and green) lighten up.
• Now connect the white balancer connector of drive battery to the jack on the right side of the charging
adapter. WARNING: the connector is polarized, note the bumps. The connector must engage with
slight pressure, you not use any force -
fire hazard!