XciteRC Flybar 185M Coax, Manual

Page: 7 / 16

17
XciteRC Flybar 185M Coax
EN
Battery charging
·
Getting started
Battery charging
WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
Charging via transmitter
• Turn on the transmitter.
• Now plug the charging adapter into the USB port on the bottom side of the transmitter. Connect the
helicopter to the adapter. The helicopter must be switched off!
• The red LED starts to light solid and displays the charging process. Charging time is about 60-70 minutes.
If the battery is fully charged, the red LED turns off.
• If the red POWER LED flashes, the transmitter batteries need to be changed.
Charging via USB port
• Insert the USB plug into a suitable socket on your PC or notebook (or power adapter with USB socket).
Connect the helicopter to the adapter. The helicopter must be switched off!
• The red LED starts to light solid and displays the charging process. Charging time is about 60-70 minutes.
If the battery is fully charged, the red LED turns off.
B A
The flight time of the helicopter is about 6-8 minutes.
Getting started
Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Switch on the model. The red LED on the receiver board starts to flash.
• Then switch on the transmitter. The POWER LED flashes.
• Place the helicopter in the start position and move the left throttle lever all the way
up and then back in the lowest position. This safety circuit prevents the rotor may
start after turning ON the helicopter
• The transmitter LED and the red helicopter LED will now light.
• Check the motor and servo functions.
• If the flight battery runs low, the motor speed is reduced and the helicopter sinks automatically. Find a
suitable place to land safely. Charge the flight battery again.