background image

19

 XciteRC Flybar 185M Coax

EN

Maintenance 

·

 Troubleshooting 

·

 Repairs

 WARNING:

 the motor of the XciteRC FLYBAR 185M may get very hot during operation. Allow to cool 

down minimum 20 minutes before the next start to avoid damage. 

Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good 
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a

harder brush or a toothbrush can be used.

• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic

of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up 
liquid.

• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.

WARNING:

 Damaged batteries or rechargeable batteries must not be used again and must be

disposed of immediately – 

fire hazard!

 Please note the disposal notes at the end of this manual.

• Check the model for worn, broken or jammed parts and gears and repair if necessary.

WARNING:

 remove the batteries / rechargeable batteries of the transmitter and model when not in

use – 

fire hazard!

Troubleshooting

Problem

Possible Cause

Corrective Action

Rotor don‘t move

ON/OFF switch is OFF
Weak helicopter battery
Transmitter - model not bound

Switch ON helicopter
Re-charge battery 
Rebind: first switch on the model, then the 
transmitter

Rotor stops sud-
denly, helicopter 
chrashes

Weak helicopter battery
Weak transmitter battery

Re-charge battery
Change transmitter batteries

The helicopter 
does not react to 
the remote control. 
Loss of control.

Gyro initialisation failure

Another radio controlled device using 
the same channel
Affected by sunlight or other strong
light

Place the model on a flat surface when 
switching on
Switch off another/own device or move to 
another spot
Avoid direct sunlight or other strong
light

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:

For car models:

 bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork

For ship models:

 damaged or broken propellers, torn superstructure

For airplanes:

 damage due to improper transportation or crash

I If you find a part that is defective in material or workmanship right after opening the package, return - before 
you used it – to your dealer or directly to us and we will send you a replacement.
For the Flybar 185M some parts are available as spares. If a part is defective or worn, you can identify it with 
the help of the exploded view.
In case of problems or questions, please contact your dealer or:

Summary of Contents for Flybar 185M Coax

















Reviews: