XCell Fury Extreme Assembly Manual
Page 74 of 138
Copyright Miniature Aircraft USA
Created: 11/14/2006
This document may not be distributed without permission of Miniature Aircraft USA
6A.1.b
Building Notes - Flip the swashplate over to its
bottom and locate the four 3mm threaded holes.
These four holes and set screws are for periodically
minimizing any free play that may develop as the
swashplate bearing wears (excessive free play can
cause inaccuracies in control inputs). Apply a small
amount of blue thread lock to the threads of the set
screws and using a 1.5mm allen driver, install each
set screw loosely into these holes. The adjustment
procedure is to rotate the inner swashplate ring
within the outer ring and adjust the set screw until a
slightly irregular or “notchy” feeling occurs, then
loosen the set screw just enough to return the
assembly to smooth operation. Repeat the
procedure for each set screw. In most cases, this
procedure should be done after every 20 gallons of
fuel. (This procedure can easily be done on an
assembled model by simply disconnecting the
related ball links.)
6A.2 - Install Swashplate – 140° Kit
6A.2.a
6A.2.b
#0051 (4)
