XCell Fury Extreme Assembly Manual
Page 30 of 138
Copyright Miniature Aircraft USA
Created: 11/14/2006
This document may not be distributed without permission of Miniature Aircraft USA
2D.3 – Install Constant Drive
2D.3.a
2D.3.b
2D.3.c
Building Notes – Do not over tighten the set screw that captures the retaining pin
Before tightening the lower main shaft collar, move the t/r pinion gear forward by 1/8”. Using two fingers hold pressure between the lower
collar and the constant drive. Now tighten the lower retaining collar
Do not over tighten the bolts in the collars! Tighten until the bolt seats on the collar and then tighten an additional ¼ turn.
2D.1.d
2D.1.e
Building Notes – reposition the t/r pinion
gear so that it’s centered on the crown
gear.
Tighten the two set screws in the pinion
gear. Make sure the one on the shaft flat is
centered on the flat
Do not over-tighten as this may distort the
gear.
Slightly Forward
#0840-6
#0057
Re-Center
