User Manual XCAT eProp
Page 30
Edition: 02-2023
5.
Detaching eProp-Motor
After using the eProp, follow the steps below to remove the VAQUITA motor from the
XCAT.
1) Long press and hold the on/off switch to turn off the battery.
2) Disconnect the connection between the VAQUITA motor and the VAQUITA battery.
3) Remove the eProp holder from the XCAT:
•
Open the hand knob.
•
Pull the locking bolt and at the same time push the holder backwards.
•
Slide the bracket with motor off the center beam.
4) Remove the steering rudder from the XCAT.
5) Slide the battery back and lift it up to remove it. Place it in a dry and safe place.
After using the VAQUITA motor in salt water, it must be cleaned
thoroughly:
First, rinse the motor thoroughly with fresh water. The motor must then
be run at low speed in a container of fresh water to prevent salt deposits
on the moving parts of the drive. Salt incrustations can cause damage to
the motor!
6.
Transport and Storage
6.1.
Transport
When transporting the eProp outboarder, pack the products in the original bags
supplied with this product.
Important notes before transport:
•
Check and ensure the package is intact without any damage.
•
Avoid violent vibration, strike or squeeze during transport. Get adequate damping
protection measures before transport.
•
Do not expose VAQUITA Battery to the sun or rain during transport.
•
Check applicable laws and regulations before transport.
