Xantrex XPower 1000 Plus, Owner'S Manual

Page: 35 / 72

Installing the XPower Plus
445-0145-01-01 3–15
Chassis Ground Screw
Xantrex recommends that you attach the cable to the chassis ground
screw with a ring terminal. This procedure will ensure that the wire does
not slip off the chassis ground screw.
To connect the cable to the chassis ground screw:
1. Make sure the inverter’s On/Off switch is in the Off position.
2. Remove chassis ground screw and star washer using #2 Phillips
screwdriver.
3. Strip 1/2 inch (13 mm) to 3/4 inch (19 mm) of insulation from one
end of each cable.
4. Attach the ring connector that will join the cable to the chassis ground
screw. The connector you use must create a permanent, low-
resistance connection. (See
“Materials” on page 3–12 .)
5. Fit the chassis ground screw through the star washer and the ring
connector back into the screw opening.
6. Tighten the chassis ground screw.
XPower 1200 Plus 1750 Plus.book Page 15 Friday, October 21, 2005 4:19 PM