Xantrex XPLORE 120/12, Owner'S Manual, Page: 19 / 68

Terminals and Ports
975-1038-01-01 7
Terminals and Ports
This section describes the inside parts of the XPLORE Charger
including the terminals and ports.
Figure 2 Rear Panel
A B C D E F
J K L M N O
G H I
Item Description
A AC input terminals - for attaching G - L - N connections from
an AC source
B BTS port - for connecting the optional battery temperature
sensor (BTS)
C Battery positive (+) - for BAT6 (group 2, 40A total output)
D Battery positive (+) - for BAT5 (group 2, 40A total output)
E Battery positive (+) - for BAT4 (group 2, 40A total output)
F Battery positive (+) - for BAT3 (group 2, 40A total output)
Item Description
G Battery positive (+) for BAT2 (group 1 120A total output)
H Battery positive (+) for BAT1 (group 1 120A total output)
I Battery negative (–), common for all six banks
J Dry contact port - for connecting a 1A relay dry contact
output used for external signaling devices
K CAN port - for connecting CAN-compatible devices using a
4-position terminal connector
L NMEA2000 port - for connecting NMEA2000-compatible
devices using a 5-position Micro-C terminal connector
M USB port - for connecting a USB stick used in copying
settings and updating firmware
c
Not to be used to power or charge USB devices.
N RJ12 expansion port - for connecting to the Xantrex BLE
Module (PN: 808-0889)
O DC ground DC neg(-) bus terminal - for connecting to
the battery negative (-) DC ground bus