Xantrex XHR 7.5-130, Operating Manual

Page: 77 / 86

Revision A
75
Section 5. Calibration
Calibration Setup
Service
Environment
and
Precautions
•
Follow established antistatic procedures.
•
Work at a bench with adequate room and support for the test unit and for all
equipment required.
•
To reduce shock hazard, use only an insulated, straight-bladed screwdriver when
calibrating trim potentiometers.
•
NEVER test these units alone. Ensure that someone is present who can help
should an accident occur.
Equipment
Required
You will need the following equipment when calibrating your supply.
•
5-1/2 digit true RMS voltmeters (DVMs) (±0.05% accuracy) with test leads.
•
Current shunt 1 mV/amp (±0.25%) and connecting wire. Current rating for the
DC shunt and connecting wire must be at least 10% greater than the power
supply’s output current rating. See also Table 2.3, “Current Carrying Capacity
for Wiring” .
•
Non-conducting, straight-bladed screwdriver.
WARNING- HIGH ENERGY AND HIGH VOLTAGE
Exercise caution when using and servicing a power supply. High energy levels
can be stored at the output voltage terminals on a power supply in normal
operation. In addition, potentially lethal voltages exist in the primary circuit and
on the output and sense connectors of a power supply with a rated output
greater than 40 V. Filter capacitors store potentially dangerous energy for some
time after power is removed.
TM-XROP-01XN.book Page 75 Monday, March 22, 2004 4:10 PM