Xantrex XHR 7.5-130, Operating Manual

Page: 20 / 86

Features and Specifications
Rear Panel Connectors and Switch
18
Operating Manual for XHR Series Power Supply
Rear Panel Connectors and Switch
The output terminals for the low voltage models (7.5 V to 40 V) are bus bars. The
high voltage models (60 V to 600 V) use a wire clamp connector. See
Figure 1.2 and
Figure 1.3 to identify the switches and connectors on the rear panel.
Use the SW1 Programming, Monitoring, and Shutdown Select switch and the J2
Programming, Monitoring, and Sense connector to choose among several remote
programming and monitoring options. See the following sections for more
information about remote programming:
•
“SW1 Programming Switch” on page 19
•
“J2 Programming Connector” on page 20
•
Section 4. Remote Operation
Rear Panel
Illustrations
Figure 1.2 Rear Panel with Bus Bar
(For 7.5 V to 40 V models.)
100/120/200/240V
50/60 HZ
1300VA
100/120/200/240V
50/60 HZ
1300VA
AC Input Connector
(See page 36 .)
SW1 Programming, Monitoring,
and Shutdown Select Switch
(See page 19 .)
J2 Programming, Monitoring, and
Sense Connector
(See page 20 for more
information.)
Negative Output
(Return) Bus Bar
Fan Exhaust Vents
(Do not block.)
Positive Output Bus Bar
(See page 39 .)
Blank Subplate
(Replaced if digital programming
interface installed.)
Ground Screw
Local Sense Wires
(See page 48 .)
TM-XROP-01XN.book Page 18 Monday, March 22, 2004 4:10 PM