Terminal Configuration
M370078-06
2-21
5. In the
Connect using:
box, select “TCP/IP (Winsock)”.
6. In the
Host address
box, enter the IP address, obtained in step 14 of
the section entitled “Assigning an IP Address to the Power Supply
Unit” on page 2–12.
7. In the Port number box, enter “10001” as the value.
8. Click
OK
.
To specify the terminal connection properties:
1. Click
Disconnect
if necessary, and click
Properties
in the main
HyperTerminal window. See Figure 2-23.
2. In the ENET Properties window, click on XGthe
Settings
tab. See
Figure 2-23
Main Terminal Window
Summary of Contents for GRIB and Ethernet interface
