Basic Installation Procedures
28
Freedom X 1200 Owner's Guide
Basic Installation Procedures
This section provides sample installation information as a guide
for your installation. For your convenience, the overall procedure
is divided into these main steps:
Installation Tools and Materials
Step 1: Designing the Installation
Step 2: Choosing a Location for the Unit
Step 4: Connecting the AC Input Wires
Step 5: Connecting AC Output to an Existing AC Circuit
Step 6: Connecting the DC Cables
Step 7: Connecting to Port(s) on the Freedom X 1200
Step 8: Testing Your Installation
NOTE
: For marine applications, see additional installation
instructions
Installation Tools and Materials
You will need the following to install the Freedom X 1200:
n
Wire stripper
n
Mounting (#2) screws or bolts
n
#2 Phillips torque screwdriver
n
3mm slot long neck screwdriver for spring clamp AC
terminals
n
Torque wrench for DC terminals (½" or 13mm socket
wrench)
n
AC cable (that is, two-conductor-plus-ground cable), sized
appropriately for load and application
n
½" trade-size strain relief clamps (for the AC cable clamp
holes)
n
Wire nuts or crimp connectors for AC wire and appropriate
tools
n
DC cable, sized appropriately for load and application
n
Lugs for DC cables to fit
5
/
16
" DC stud terminals as well as
appropriate tools (like a crimping tool)
n
AC and DC disconnects and over-current protective devices
Summary of Contents for Freedom X 1200
Page 2: ......
Page 26: ...This page is intentionally left blank 2...
Page 82: ...This page is intentionally left blank 2...