Xantrex Freedom X 1200, Owner'S Manual, Page: 49 / 100

Basic Installation Procedures
975-0767-01-01 47
Figure 11 Parts inside the AC compartment
4a
4b
1a
1b
5 6
8
2b 2a
3a 3b
9 10 11
12
13 L G
AC OUT
N N G
AC IN
L
7
1 5" (127mm) black stranded wire. 1a (stripped) and 1b (straight ferrule)
2 5" (127mm) green stranded wire. 2a (spade ferrule) and 2b (straight ferrule)
3 5" (127mm) white stranded wire. 3a (spade ferrule) and 3b (straight ferrule)
4 15 A supplementary protector with two wires 4a (bottom, spade ferrule) and 4b (top, stripped)
5 GFCI's LOAD terminals (top and bottom). The two terminals may or may not be covered by a
yellow tape.
c
DO NOT REMOVE THE TAPE .
6 GFCI's LINE for Neutral. Silver terminal (bottom)
7 GFCI's LINE for Live. Brass terminal (top)
8 GFCI's Ground terminal (green)
9 Inverter AC OUT - ( L )ine terminal
10 Inverter AC OUT - ( G )round terminal
11 Inverter AC OUT - ( N )eutral terminal
12 GFCI's mounting screws. Use the two outer holes.
13 Twist-on wire connector
Match the wire connectors to the corresponding terminals:
1. Connect each AC wire into its corresponding terminal on the
no-tool cage clamp terminal block by lifting the terminal
lever, insert the ferrule fully into the open slot, and lowering
the terminal lever to secure the wire in the slot.
a. Connect 1b to 9 .
b. Connect 2b to 10 .
c. Connect 3b to 11 .
Make sure that each AC wire is matched and connected to
the Line (
L ), Ground ( G ), and Neutral ( N ) connections.
2. Splice 1a and 4b using a twist-on wire connector as shown
in Figure 11 item 13.
3. Connect 2a to 8 .
4. Connect 3a to 6 .
5. Connect 4a to 7 .
6. Attach and secure the GFCI receptacle to the panel inside
the wiring compartment using the two mounting screws as
shown in
Figure 11 item 12.
Figure 12 Wiring diagram
L G
AC OUT
N N G
AC IN
L