Xantrex 817-2000-12, Owner'S Manual

Page: 49 / 92

Basic Installation Procedures
975-0822-01-01 35
Description of Ignition Control Features
For information about the features and instructions on changing
the ignition control features, see
Operation on page 41 .
Ignition Auto-
on ( ATO )
This setting allows the inverter to operate
(Battery mode) automatically when an
ignition control wire is connected to the
ACC input and a valid ignition signal is
constantly detected. The inverter works in
tandem with the vehicle’s ignition circuit.
Ignition Lock-
out ( LOt )
This setting allows the inverter to operate
(Battery mode) when an ignition control
wire is connected to the ACC input
terminal and a valid ignition signal is
constantly detected.
When enabled, you have to manually
press the Power button on the display
panel to operate the inverter.
Off ( OFF )
To completely disable the ignition control
features do the following:
Set Ignition Control to Off ( OFF ) using the
Select buttons on the Display panel.
Table 9 Ignition Control Features
Connecting to the Remote Port
The Freedom X can accommodate the Freedom X Remote Panel
with cable (PN: 808-0817-01) (sold separately; comes with 7.6m-
cable) or the Freedom X Remote Panel unit (PN: 808-0817) (sold
separately; unit only without cable).
To connect the remote panel to the remote port:
n
Plug the remote panel unit's cable connector to the RJ12
Remote port on the unit.
NOTE : When the remote panel is connected, turn the inverter’s
Power button to to Standby (up position). This allows the remote
panel to control the inverter’s power status.