Xantrex 806-1020, Owner'S Manual, Page: 51 / 62

975-0390-01-01 37
Warning Messages
For error code  :
• the display screen and the alarm will turn off after 30 seconds
a
• after a five-minute shutdown delay
b
, the unit will immediately
stop inverting
For error codes

to

:
• the unit will stop inverting
For error codes  and  :
• the unit will stop charging, but
• the error code will still show on the display screen and the
alarm will remain on, and
• AC power will continue to pass through to the AC outlets
For error code 
• the unit will stop charging and shut down, and
• the error code will show on the display screen briefly, and
• AC power will not pass through to the AC outlets
To reset error codes

to

:
1. Remove the AC input.
2. Turn the unit OFF and then turn ON again using the Inverter
Power button on the display panel.
 Battery is bad or external DC
load is connected to the battery. AC shore power • Check the battery bank.
NOTE : The battery voltage did not rise above 5 volts DC after 1
minute or 10 volts DC after 15 minutes.
• Check that the external DC load current consumption is below the
charging current setting.
• Disconnect the DC load or increase the charger current setting.
Table 7 Error Codes Displayed on the Display Panel Screen
Error Code Condition Mode Action
a.Available in all models (including PN: 806-1840-01 G2 TDN8853) except Freedom
HF 1500 and 1800 T. See page 22.
b.Available only for the Freedom HF 1500 and 1800 T models. See page 23.
Freedom HF InvChg Owners Guide.book Page 37 Wednesday, September 13, 2017 6:20 PM