08905084D
-
6
-
RF2IR Configuration (Channel Address)
The Channel Address on the RF2IR cannot be programmed using Universal Dragon. Located on the
bottom of the RF2IR device is a rotary switch. Turn this switch to select the desired Channel Address.
The switch is labeled in HEX notation. “A” stands for Channel Address “10”. “B” stands for Channel
Address “11”. The Channel Address increments with the alphabet until it ends at “F”, which is “15”.
XTR39 Setup Page, Changing the “Channel Address”
NOTE: The XTR39 firmware version must be greater than 1.11. To check the firmware, follow the
steps below. At Step 2, select “System Info”.
Step 1: Press the “Mute” button on the XTR39 and hold it for more than 5 seconds. The XTR39 will
enter the setup page.
Step 2: Select the “System Settings” button. A new page will appear
Step 3: Press the “Down” or “Up” button to change the “Channel Address”. The “Channel Address” on
the XTR39 and RF2IR needs to identical.
Up and Down Arrows